How to install drop in anchor

2016年07月22日　來源: 機械錨栓|車修壁虎|地腳螺栓|六角套管壁虎|邯鄲市海威五金制品有限公司

1.Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/8" for flush mounting. Blow the hole clean using compressed air. Overhead installations need not be blown clean.

2.Insert designated anchor into hole. Tap with hammer until flush against surface.

3.Using the designated drop-in setting tool, drive expander plug toward the bottom of the anchor until shoulder of setting tool makes contact with the top of the anchor.

4.Minimum thread engagement should be equal to the nominal diameter of the threaded insert.

This is the process of installing drop in anchor